Cub Cadet I-Beam Style - Manual (Page 247)

6-48
10. Retract the wedge assembly fully.
11. Shut the engine off and fill the reservoir
assembly to the correct level.
12. Start the engine and extend and retract the
wedge assembly 10 to 12 full cycles to remove
trapped air in the system. See Figure 6-46.
NOTE
The log splitter hydraulic system is self bleed-
ing.
13. Shut the engine off and fill the reservoir
assembly to the correct level. See Figure 6-47.
NOTE
Never allow the reservoir fluid to drop below
the minimum level, or damage may occur to
the hydraulic pump.
IMPORTANT: Some hydraulic fluid may over-
flow from the vent plug as the system tempera-
ture increases and the hydraulic fluid expands
and seeks its own level.
Figure 6-45.
Figure 6-47.
Figure 6-46.
Log Splitters 2.fm Page 48 Wednesday, February 20, 2002 1:35 PM