Cub Cadet I-Beam Style - Manual (Page 244)

6-45
6
2. Disconnect the high pressure hydraulic hose
from the 45 degree pump adapter using two
7/8" wrenches.
3. With a partner or a mechanical aid, raise the
beam assembly to the vertical position until it is
standing on the rectangular foot. See Figure 6-
36
NOTE
The cylinder should be towards the top.
4. Remove the cotter pin and clevis pin from the
brackets that attach the beam assembly to res-
ervoir frame assembly using a pair of pliers.
See Figure 6-37.
5. Grasp the tongue assembly and raise it up.
6. Roll the reservoir frame assembly into position
up against the beam assembly.
7. Install the clevis pin previously removed.
8. Secure the clevis pin in place with the cotter
pin removed earlier using a pair of pliers.
NOTE
Bend the ends of the cotter pin in both direc-
tions using a pair of pliers.
Return Hose Installation
1. Cut the securing strap holding the return hose
to the top of the control valve using a pair of
side cutters.
2. Loosen the hose clamp at the free end of the
return hose using a 5/16" socket or a flat-blade
screwdriver. See Figure 6-38.
Figure 6-35.
Figure 6-36.
Figure 6-37.
Log Splitters 2.fm Page 45 Wednesday, February 20, 2002 1:35 PM