Cub Cadet I-Beam Style User Manual
Page 150
5-11
5
5-1.2
Operating Controls.
1.
Squeeze control handle to engage augers and
drive unit forward. Pushing downward on han-
dle will raise augers off the ground and stop
the forward motion. See Figure 5-5.
NOTE
Excessive upward pressure on the handle will
cause premature wear on rubber auger blades.
The depth of snow will affect the forward speed
(e.g., the deeper the snow, the slower the for-
ward speed).
2.
Release control handle to stop snow throwing
action.
5-1.3
Belt Removal or Replacement.
1.
Remove belt cover by removing screws with a
3/8 inch wrench and (if applicable) a Phillips
screwdriver. See Figure 5-6.
2.
Pull upward on idler pulley and slip belt off
engine pulley. See Figure 5-7.
3.
Push down on idler pulley and slip belt off
auger pulley. See Figure 5-7.
4.
Reassemble new belt in reverse order.
SNOW THROWER.fm Page 11 Wednesday, February 20, 2002 10:28 AM