Cub Cadet I-Beam Style - Manual (Page 184)

5-45
5
1994 to Present:
NOTE
It is necessary to remove both belts in order to
change either one. If changing just one belt, be
certain to check the condition of the other belt
(model 616E has only one auger belt).
1. Remove the plastic belt cover on the front of
the engine by removing the two self-tapping
screws. See Figure 5-81.
2. Drain the gasoline from the snow thrower, or
place a piece of plastic under the gas cap.
3. Tip the snow thrower up and forward so that it
rests on the housing.
4. Remove six self-tapping screws from the frame
cover underneath the snow thrower.
5. Roll the front and rear auger belts off the
engine pulley. See Figure 5-82.
6. Unhook the idler spring from the hex bolt on
the auger housing.
7. Unhook the support bracket spring from the
frame.
8. Lift the front auger belt from the auger pulley,
and slip belt between the support bracket and
the auger pulley. Repeat this step for rear
auger belt (except model 616E).
9. Replace both auger drive belts by following
instructions in reverse order.
SNOW THROWER.fm Page 45 Wednesday, February 20, 2002 10:28 AM