Cub Cadet I-Beam Style - Manual (Page 155)

5-16
5-2. 20-INCH SNOW THROWER MODEL 225
(See Figure 5-11).
5-2.1 Drive Clutch Control Adjustment.
1. Hold clutch grip so that grip is approximately
1/4 inch away from handle. See Figure 5-12.
CAUTION
Do not overtighten control wire. Too much ten-
sion may cause it to break.
2. Adjust clutch control cable so that the slack is
taken out of control wire by adjusting two hex
nuts at cable support bracket.
3. After tightening the two hex nuts the control
wire should now be straight; if not, readjust.
5-2.2 Auger Clutch Control Adjustment. To check
for correct adjustment, squeeze auger clutch
grip against handle so lockout rod is engaged.
With lockout rod engaged, you should be able
to get a matchbook cover between the coils of
the compression spring (spring should not be
compressed tightly). If there is no space
between spring coils, adjust lock nut using a 7/
16 inch wrench until correct adjustment is
reached. See Figure 5-13.
5-2.3 Shift Rod Adjustment. With both shift lever
and shift rod in neutral, thread shift rod in or
out of the ferrule as necessary until the end of
the rod lines up with the hole in shift lever.
Insert end of rod into hole in shift lever and
secure with hairpin cotter. See Figure 5-14.
SNOW THROWER.fm Page 16 Wednesday, February 20, 2002 10:28 AM