Cub Cadet I-Beam Style - Manual (Page 99)

3-80
26.Remove the clevis pins and hair pins securing
the right and left tine assemblies. See Figure
3-231.
27.Remove both tine assemblies from the tine
shaft assembly.
NOTE
Make certain the tine shaft is lubricated during
assembly.
28.Remove all four hex bolts securing the left por-
tion of the shoulder spacer bracket to the tine
shield and gear case assembly using a 1/2"
socket and a 1/2" wrench. See Figure 3-232.
NOTE
The outer two hex bolts are shorter then the
middle two hex bolts.
29.Remove all four hex bolts securing the right
portion of the shoulder spacer bracket to the
tine shield and gear case assembly using a 1/
2" socket and a 1/2" wrench. See Figure 3-
233.
NOTE
The outer two hex bolts are shorter than the
middle two hex bolts.
30.Remove all four hex nuts, lock washers, and
carriage bolts securing the handle brackets to the
tine shield using a 9/16” socket. See Figure 3-
234.
Tillers.fm Page 80 Tuesday, February 19, 2002 1:28 PM