Winco DGC-2020 - Manual (Page 135)

Figure 4-60. Programmable Senders Settings
A Sender Points: Accepts up to 11 user-defined sender resistance points.
B Sender Slope: Positive or Negative causes sender points to be sorted and displayed accordingly.
C Sender Point Curve: Automatic plot of sender points data.
D Print This Graph: Click to print sender point curve.
E Save Cool. Data: Click to save file containing sender point data.
F Load Cool. Settings File: Click to clear all user-defined sender data and revert to the factory-default
values.
G Create Cool. Settings File: Click to create a new settings file by entering sender point data.
BESTLOGIC+ PROGRAMMABLE LOGIC
BESTlogic+ Programmable Logic is used to set all logic functions in the DGC-2020. For detailed
information on using BESTlogic+, refer to Section 5, BESTlogic+ Programmable Logic.
Logic Timers
Refer to Section 5, BESTlogic+ Programmable Logic, for information on using logic timers.
FILE MANAGEMENT
These paragraphs describe file management of settings files, firmware files, and language module files.
Settings Files
These paragraphs describe the tasks of opening, uploading, downloading, saving, printing, and
comparing of settings files. When opening, uploading, downloading, or saving a settings file, operational
settings, as well as BESTlogic+ settings are combined together as a whole. When printing a settings file,
only the operational settings are shown. There is a separate print option available on the BESTlogic+
Programmable Logic screen for printing BESTlogic+ settings. For information on solely uploading or
downloading BESTlogic+ settings, refer to Section 5, BESTlogic+ Programmable Logic.
A settings file conversion is required when DGC-2020 firmware has been changed so that the settings file
is compatible with the firmware. For information on converting settings files, see Converting Settings
Files,
later in this section.
9400200990 Rev K DGC-2020 BESTCOMSPlus Software 4-65