Winco DGC-2020 - Manual (Page 5)

9400200990 Rev K DGC-2020 Introduction iii
REVISION HISTORY
The following information provides a historical summary of the changes made to this instruction manual
(9400200990), BESTCOMSPlus software, firmware package, and hardware of the DGC-2020.
Manual
Revision and Date Change
K, 01/09  Updated manual to support firmware version 1.08.01 changes and
BESTCOMSPlus version 2.03.00 changes. (See firmware and
BESTCOMSPlus history below for details.)
 Removed duplicate Speed Controller Tuning Procedure from
Appendix C.
 In Appendix B, added additional information for registers 40436 -
40476.
J, 08/08
 Added Section 10, AEM-2020 (Analog Expansion Module).
 Added information for Automatic Generator Detection in Section 4.
 Improved CANbus diagrams and notes throughout manual.
 Added information for Integrating Reset function in Section 4.
 Added information for Configurable Protection in Section 4.
 Improved definition of Emergency Stop Input in Section 6.
 Added installation diagrams for MTU MDEC ECU in Section 6.
 Added Typical LSM-2020 Interconnection Diagram in Section 8.
 Enhanced Section 7, Maintenance and Troubleshooting.
 Added
Synchronizer Operation under Breaker Management in
Section 3.
 Improved
Communication in Section 4.
 Added Bits 6 through 10 to register 44822 in Appendix B.
 Added Appendix C, Tuning PID Settings.
I, 07/08
 Changed Output Contacts 13 through 24 rating from 2 Adc to 1 Adc.
 Changed Output Contacts 25 through 36 rating from 10 Adc to 4 Adc.
H, 02/08  Added Section 9, CEM-2020 (Contact Expansion Module).
G, 11/07  Added Section 8, LSM-2020 (Load Share Module).
 Updated HMI screens layout in Section 2.
 Added BESTCOMSPlus Multigen Management screens.
F, 08/07  Updated manual to support firmware version 1.02.00 changes and
BESTCOMSPlus version 1.03.00 changes. (See firmware and
BESTCOMSPlus history below for details.)
E, 05/07  Added description of Clock Setup screen in BESTCOMSPlus.
 Updated several BESTCOMSPlus screen shots.
 Increased Low Coolant Temp Pre-Alarm range to 30 - 150F.
D, 03/07  Removed International Modem option from Style Chart in Section 1.
 Added coverage of part numbers 9400200105 and 9400200106.
C, 02/07  Added
Event Recording in Section 3, Functional Description.
 Minor text edits throughout manual.
B, 11/06  Initial
release