Winco DGC-2020 - Manual (Page 75)

Figure 4-7. DGC-2020 Connection
USB Communication
If connecting to the DGC-2020 through a USB cable, select USB via Serial RS232, USB, and enter COM
Port.
The USB drivers are installed automatically during the BESTCOMSPlus installation process. To
select the correct COM Port, open Windows  Device Manager and expand the Ports (COM & LPT)
branch. Locate the device named CP2101 USB to UART Bridge Controller (COMx). The COM Port
number will be displayed in parenthesis (COMx). Be sure operating power is applied to the DGC-2020
and the USB cable is connected before opening the Device Manager. See Figure 4-8.
Figure 4-8. Windows

Device Manager
Installing the USB Driver if Automatic Installation Fails
To install the USB driver for the DGC-2020:
1. Apply operating power to the DGC-2020 and wait for the boot sequence to complete.
2. Plug the proper end of the USB cable into the PC and the other end into the DGC-2020.
3. The
Found New Hardware Wizard dialog box appears.
4. Select “No, not this time” and select Next to continue.
5. Choose to “Install from a list or specific location (Advanced)” and select Next to continue.
6. Insert the CD-ROM labeled BESTCOMSPlus into the PC CD-ROM drive.
7. Browse to the \driver folder on the CD-ROM and select Next to continue.
When installation of the driver is complete, you may be asked to restart your computer.
9400200990 Rev K DGC-2020 BESTCOMSPlus Software 4-5