Remote module setup, Load sharing module, Remote module setup -24 – Winco DGC-2020 User Manual
Page 94: Figure 4-20. system settings -24
Figure 4-20. System Settings
A
Generator Connection: Delta, Wye, 1-Phase A-B, 1-Phase A-C, or Grounded Delta.
B
Genset kW Rating: Adjustable from 5 to 9,999 kW in 1 kW increments.
C
Rated Volts: Adjustable from 1 to 999 Vac in 1 Vac increments.
D
Rated Power Factor:
Adjustable from –1 to +1 in increments of 0.001.
E
Speed Signal Source: MPU, Gen Freq, or MPU Freq.
F
Rated Frequency: 50/60 or 400 Hz.
G
Rated Engine RPM: Adjustable from 750 to 3,600 rpm in 1 rpm increments.
H
Number Fly Wheel Teeth: Adjustable from 50 to 500 in increments of 1.
I
Off Mode Cool Down Enable: Enable or Disable.
J
No Load Cool Down Time: Adjustable from 0 to 60 minutes in 1 minute increments.
K
EPS Current Threshold: Adjustable from 3 to 10% of the CT primary rating in 1% increments.
L
Low Line Scale Factor: Adjustable from 0 to 3.000 in increments of 0.001.
M
System Units: English or Metric.
N
Battery Volts: 12 or 24 Vdc.
O
NFPA Level: 0 disables NFPA compliance, 1 enables Level 1 NFPA compliance, 2 enables Level 2.
P
Horn: Enable or Disable.
Q
Single Phase Override Sensing: A-B or A-C.
R
Fuel Level Function: Disable, Fuel Lvl, Natural Gas, or Liquid Propane.
S
Power Up Delay: Adjustable from 0 to 60 seconds in 1 second increments.
T
Auto Config Detection: Enable or Disable.
U
Single Phase Detect Threshold: Adjustable from 0 to 480 V in 1 V increments.
V
Low Line Detect Threshold: Adjustable from 0 to 480 V in 1 V increments.
W
Single Phase Detection Generator Connection: A-B or A-C.
X
Start: Predefined or Programmable.
Y
Run: Predefined or Programmable.
Z
Prestart: Predefined or Programmable.
Remote Module Setup
The following settings are used to configure the LSM-2020, CEM-2020, and AEM-2020.
Load Sharing Module
A J1939 Address
A
must be entered when an optional LSM-2020 is enabled
B
.
4-24
DGC-2020 BESTCOMSPlus Software
9400200990 Rev K