Part numbers, Specifications, Operating power – Winco DGC-2020 User Manual
Page 16: Power consumption, Battery ride through, Current sensing, 1 aac current sensing, 5 aac current sensing, Voltage sensing, Part numbers -4
1-4
DGC-2020 General Information
9400200990 Rev K
Part Numbers
A ten-digit part number specifies the electrical characteristics and operational features of special-order
DGC-2020 controllers. Table 1-1 lists the special-order DGC-2020 controllers available along with
descriptions of their operating features.
Table 1-1. Special-Order DGC-2020 Controllers
Part Number
Style Number
Special Features
9400200105 51ANBNSNH001
9400200106 11ANBNSNH001
cURus recognized for use in
hazardous locations.
SPECIFICATIONS
Operating Power
Nominal:
12 or 24 Vdc
Range:
6 to 32 Vdc (Withstands cranking ride-through down to 6 Vdc
for 500 ms.)
Terminals:
3 (+), 2 (–), 1 (chassis ground)
Power Consumption
Sleep Mode:
5W with all relays non-energized
Normal Operational Mode:
7.9W - Run mode, LCD heater off, 3 relays energized
Maximum Operational Mode:
14.2W - Run mode, LCD heater on, 6 relays energized
Battery Ride Through
Withstands cranking ride-through down to 0 V for 50 ms.
Current Sensing
Burden:
1 VA
Terminals:
68, 69 (A-phase)
71,
72
(B-phase)
74,
75
(C-phase)
1 Aac Current Sensing
Continuous Rating:
0.02 to 1.0 Aac
1 Second Rating:
2 Aac
5 Aac Current Sensing
Continuous Rating:
0.1 to 5.0 Aac
1 Second Rating:
10 Aac
Voltage Sensing
Configuration:
Line-to-line or line-to-neutral
Range:
12 to 576 V rms, line-to-line
Frequency:
Style selectable, 50/60 Hz or 400 Hz
Frequency Range:
10 to 72 Hz for 50/60 style and 10 to 480 Hz for 400 Hz style
Burden:
1 VA
1 Second Rating:
720 V rms
Generator Sensing Terminals:
41 (A-phase)
39
(B-phase)
37
(C-phase)
35
(Neutral)
Bus Sensing Terminals:
45 (A-phase)
43
(B-phase)