Winco DGC-2020 - Manual (Page 153)

Figure 4-86. Metering, Event Log, Sorted by Date
When viewed with BESTCOMSPlus, the event log can be sorted by Event ID, Description, Occurrence,
Date, or Engine Hours. Selecting event log sorted by Date yields a list of all event occurrences in
sequential order. This is a view that one would see in a typical “sequence of events” type of event log.
Figure 4-86 shows the sequential list resulting from sorting by Date. Sorting by engine hours also results
in a sequential list, where the sequence is in terms of engine hours rather than calendar date and time.
Selecting sorting by Event ID or Description allows one to view all the occurrences of a particular event
type in their order of occurrence. In this view, one can see at a glance the times and dates of the
occurrences of one type of event. For example, from Figure 4-87, if one wanted to know when all
occurrences of Speed Sender Failures occurred, the information readily available without having to sift
through all the occurrences of unrelated events as would have to be done in a rolling log implementation.
This is apparent in Figure 4-86.
Figure 4-87. Metering, Event Log, Sorted by Event ID
J1939 ECU
The ECU reports operating information to the DGC-2020 through the CANbus interface when the ECU is
configured for Volvo Penta. Operating parameters and diagnostic information, if supported by the ECU,
are decoded and displayed on these screens.
ECU Data
This screen displays ECU Lamp Status and ECU Data. The status is TRUE when the corresponding LED
is red. Refer to Figure 4-88.
9400200990 Rev K DGC-2020 BESTCOMSPlus Software 4-83