Altera Arria V Avalon-ST - Manual (Page 243)

Additional Information
C
2014.12.15
Subscribe
Send Feedback
Revision History for the Avalon-St Interface
Date Version Changes Made
2014.12.15 14.1 Made the following changes to the user guide:
• In the figured titled Specifying the Number of Transceiver
Interfaces for Arria V and Cyclone V Devices, removed the
checkmark Calibrate duty cycle during power up. Duty cycle
calibration occurs during Gen1 to Gen2 speed changes.
• Corrected discussion of soft and hard reset controllers. The
hardened reset controller is used for Arria V and Cyclone V
devices.
• Added simulation log file, altpcie_monitor_<dev>_dlhip_tlp_file_
log.log in your simulation directory. Generation of the log file
requires the following simulation file, <install_dir>altera/altera_pcie/
altera_pcie_a10_hip/altpcie_monitor_a10_dlhip_sim.sv , that was not
present in earlier releases of the Quartus II software.
• Added statement that the bottom left hard IP block includes the
CvP functionality for flip chip packages. For other package types,
the CvP functionality is in the bottom right block.
• Corrected bit definitions for
CvP Status
register.
• Updated definition of
CVP_NUMCLKS
in the
CvP Mode Control
register.
• Added definitions for
test_in[2]
,
test_in[6]
and
test_in[7]
.
• Corrected Channel Utilization table for x1 instances. Data is
driven on Channel 0. The CMU clock is on Channel 1.
2014.06.30 14.0
Made the following changes to the Arria V Hard IP for PCI Express:
• Increased the size of
lmi_addr
to 15 bits.
© 2014 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as
trademarks or service marks are the property of their respective holders as described at www.altera.com/common/legal.html . Altera warrants performance
of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any
products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,
product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device
specifications before relying on any published information and before placing orders for products or services.
ISO
9001:2008
Registered
www.altera.com
101 Innovation Drive, San Jose, CA 95134