Microsens MS453490M Management Guide - Manual (Page 128)

C HAPTER 5 | Interface Configuration
Port Configuration
– 128 –
Figure 33: Configuring Remote Port Mirroring (Destination)
S HOWING P ORT OR
T RUNK S TATISTICS
Use the Interface > Port/Trunk > Statistics or Chart page to display
standard statistics on network traffic from the Interfaces Group and
Ethernet-like MIBs, as well as a detailed breakdown of traffic based on the
RMON MIB. Interfaces and Ethernet-like statistics display errors on the
traffic passing through each port. This information can be used to identify
potential problems with the switch (such as a faulty port or unusually
heavy loading). RMON statistics provide access to a broad range of
statistics, including a total count of different frame types and sizes passing
through each port. All values displayed have been accumulated since the
last system reboot, and are shown as counts per second. Statistics are
refreshed every 60 seconds by default.
N OTE :
RMON groups 2, 3 and 9 can only be accessed using SNMP
management software.
CLI R EFERENCES
◆ "show interfaces counters" on page 709
P ARAMETERS
These parameters are displayed:
Table 5: Port Statistics
Parameter Description
Interface Statistics
Received Octets The total number of octets received on the interface, including
framing characters.
Transmitted Octets The total number of octets transmitted out of the interface,
including framing characters.
Received Errors The number of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol.