Microsens MS453490M Management Guide - Manual (Page 630)

C HAPTER 24 | Authentication Commands
802.1X Port Authentication
– 630 –
C OMMAND M ODE
Interface Configuration
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout held-period 120
Console(config-if)#
dot1x timeout start-
period
This command sets the time that a supplicant port waits before resending
an EAPOL start frame to the authenticator. Use the no form to restore the
default setting.
S YNTAX
dot1x timeout start-period seconds
no dot1x timeout start-period
seconds - The number of seconds. (Range: 1-65535)
D EFAULT
30 seconds
C OMMAND M ODE
Interface Configuration
E XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout start-period 60
Console(config-if)#
show dot1x This command shows general port authentication related settings on the
switch or a specific interface.
S YNTAX
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
C OMMAND M ODE
Privileged Exec