Microsens MS453490M Management Guide - Manual (Page 797)

C HAPTER 34 | VLAN Commands
Configuring IEEE 802.1Q Tunneling
– 797 –
7. Configure the QinQ tunnel uplink port to dot1Q-tunnel uplink mode
(
switchport dot1q-tunnel mode ).
8. Configure the QinQ tunnel uplink port to join the SPVLAN as a tagged
member (
switchport allowed vlan ).
Limitations for QinQ
◆ The native VLAN for the tunnel uplink ports and tunnel access ports
cannot be the same. However, the same service VLANs can be set on
both tunnel port types.
◆ IGMP Snooping should not be enabled on a tunnel access port.
◆ If the spanning tree protocol is enabled, be aware that a tunnel access
or tunnel uplink port may be disabled if the spanning tree structure is
automatically reconfigured to overcome a break in the tree. It is
therefore advisable to disable spanning tree on these ports.
dot1q-tunnel
system-tunnel-
control
This command sets the switch to operate in QinQ mode. Use the no form
to disable QinQ operating mode.
S YNTAX
[no] dot1q-tunnel system-tunnel-control
D EFAULT S ETTING
Disabled
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
QinQ tunnel mode must be enabled on the switch for QinQ interface
settings to be functional.
E XAMPLE
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#
R ELATED C OMMANDS
show dot1q-tunnel ( 799 )
show interfaces switchport (711)