Snmp-server enable port, Traps atc multicast-alarm, Fire – Microsens MS453490M Management Guide User Manual
Page 750: Traps atc multicast, Control-apply, Snmp-server enable, Port-traps atc, Multicast-alarm-fire, Multicast-control, Apply
C
HAPTER
31
| Automatic Traffic Control Commands
– 750 –
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-clear
Console(config-if)#
R
ELATED
C
OMMANDS
auto-traffic-control action (744)
auto-traffic-control alarm-clear-threshold (745)
snmp-server enable
port-traps atc
multicast-alarm-fire
This command sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control. Use the no form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc multicast-alarm-fire
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-alarm-fire
Console(config-if)#
R
ELATED
C
OMMANDS
auto-traffic-control alarm-fire-threshold (746)
snmp-server enable
port-traps atc
multicast-control-
apply
This command sends a trap when multicast traffic exceeds the upper
threshold for automatic storm control and the apply timer expires. Use the
no form to disable this trap.
S
YNTAX
[no] snmp-server enable port-traps atc multicast-control-apply
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet)