Microsens MS453490M Management Guide - Manual (Page 521)

C HAPTER 21 | System Management Commands
Line
– 521 –
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Telnet is considered a virtual terminal connection and will be shown as
“VTY” in screen displays such as show users . However, the serial
communication parameters (e.g., databits) do not affect Telnet
connections.
E XAMPLE
To enter console line mode, enter the following command:
Console(config)#line console
Console(config-line)#
R ELATED C OMMANDS
show line (529)
show users (507)
databits This command sets the number of data bits per character that are
interpreted and generated by the console port. Use the no form to restore
the default value.
S YNTAX
databits {7 | 8}
no databits
7 - Seven data bits per character.
8 - Eight data bits per character.
D EFAULT S ETTING
8 data bits per character
C OMMAND M ODE
Line Configuration
C OMMAND U SAGE
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits
per character.
E XAMPLE
To specify 7 data bits, enter this command:
Console(config-line)#databits 7
Console(config-line)#