Microsens MS453490M Management Guide - Manual (Page 597)

C HAPTER 24 | Authentication Commands
AAA
– 597 –
group - Specifies the server group to use.
radius - Specifies all RADIUS hosts configure with the radius-
server host command.
tacacs+ - Specifies all TACACS+ hosts configure with the
tacacs-server host command.
server-group - Specifies the name of a server group configured
with the aaa group server command. (Range: 1-255 characters)
D EFAULT S ETTING
Accounting is not enabled
No servers are specified
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
Note that the default and method-name fields are only used to describe
the accounting method(s) configured on the specified RADIUS or TACACS+
servers, and do not actually send any information to the servers about the
methods to use.
E XAMPLE
Console(config)#aaa accounting dot1x default start-stop group radius
Console(config)#
aaa accounting exec This command enables the accounting of requested Exec services for
network access. Use the no form to disable the accounting service.
S YNTAX
aaa accounting exec {default | method-name}
start-stop group {radius | tacacs+ |server-group}
no aaa accounting exec {default | method-name}
default - Specifies the default accounting method for service
requests.
method-name - Specifies an accounting method for service
requests. (Range: 1-255 characters)
start-stop - Records accounting from starting point and stopping
point.