Microsens MS453490M Management Guide - Manual (Page 789)

C HAPTER 34 | VLAN Commands
Configuring VLAN Interfaces
– 789 –
interface vlan This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface.
S YNTAX
[no] interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
E XAMPLE
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
R ELATED C OMMANDS
shutdown (705)
interface (700)
vlan (787)
switchport
acceptable-frame-
types
This command configures the acceptable frame types for a port. Use the
no form to restore the default.
S YNTAX
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
all - The port accepts all frames, tagged or untagged.
switchport ingress-
filtering
Enables ingress filtering on an interface IC
switchport mode Configures VLAN membership mode for an interface IC
switchport native vlan Configures the PVID (native VLAN) of an interface IC
switchport priority default Sets a port priority for incoming untagged frames IC
vlan-trunking Allows unknown VLANs to cross the switch IC
Table 106: Commands for Configuring VLAN Interfaces (Continued)
Command Function Mode