Microsens MS453490M Management Guide - Manual (Page 316)

C HAPTER 14 | Security Measures
ARP Inspection
– 316 –
■
Src-MAC – Validates the source MAC address in the Ethernet
header against the sender MAC address in the ARP body. This check
is performed on both ARP requests and responses.
◆ Log Message Number – The maximum number of entries saved in a
log message. (Range: 0-256; Default: 5)
◆ Log Interval – The interval at which log messages are sent.
(Range: 0-86400 seconds; Default: 1 second)
W EB I NTERFACE
To configure global settings for ARP Inspection:
1. Click Security, ARP Inspection.
2. Select Configure General from the Step list.
3. Enable ARP inspection globally, enable any of the address validation
options, and adjust any of the logging parameters if required.
4.
Click Apply.
Figure 179: Configuring Global Settings for ARP Inspection
C ONFIGURING VLAN
S ETTINGS FOR ARP
I NSPECTION
Use the Security > ARP Inspection (Configure VLAN) page to enable ARP
inspection for any VLAN and to specify the ARP ACL to use.
CLI R EFERENCES
◆ "ARP Inspection" on page 673
C OMMAND U SAGE
ARP Inspection VLAN Filters (ACLs)
◆ By default, no ARP Inspection ACLs are configured and the feature is
disabled.
◆ ARP Inspection ACLs are configured within the ARP ACL configuration
page (see page 310 ).