Microsens MS453490M Management Guide - Manual (Page 946)

C HAPTER 41 | IP Interface Commands
IPv6 Interface
– 946 –
C OMMAND U SAGE
◆ The time limit configured by this command allows the switch to detect
unavailable neighbors.
E XAMPLE
The following sets the reachable time for a remote node to 1000
milliseconds:
Console(config)#interface vlan 1
Console(config)#pv6 nd reachable-time 1000
Console(config)#
clear ipv6 neighbors This command deletes all dynamic entries in the IPv6 neighbor discovery
cache.
C OMMAND M ODE
Privileged Exec
E XAMPLE
The following deletes all dynamic entries in the IPv6 neighbor cache:
Console#clear ipv6 neighbors
Console#
show ipv6
neighbors This command displays information in the IPv6 neighbor discovery cache.
S YNTAX
show ipv6 neighbors [vlan vlan-id | ipv6-address]
vlan-id - VLAN ID (Range: 1-4093)
ipv6-address - The IPv6 address of a neighbor device. You can
specify either a link-local or global unicast address formatted
according to RFC 2373 “IPv6 Addressing Architecture,” using 8
colon-separated 16-bit hexadecimal values. One double colon may
be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields.
D EFAULT S ETTING
All IPv6 neighbor discovery cache entries are displayed.
C OMMAND M ODE
Privileged Exec