Microsens MS453490M Management Guide - Manual (Page 795)

C HAPTER 34 | VLAN Commands
Displaying VLAN Information
– 795 –
Console(config)#interface ethernet 1/9
Console(config-if)#vlan-trunking
Console(config-if)#interface ethernet 1/10
Console(config-if)#vlan-trunking
Console(config-if)#
D ISPLAYING VLAN I NFORMATION
This section describes commands used to display VLAN information.
show vlan This command shows VLAN information.
S YNTAX
show vlan [id vlan-id | name vlan-name]
id - Keyword to be followed by the VLAN ID.
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
name - Keyword to be followed by the VLAN name.
vlan-name - ASCII string from 1 to 32 characters.
D EFAULT S ETTING
Shows all VLANs.
C OMMAND M ODE
Normal Exec, Privileged Exec
E XAMPLE
The following example shows how to display information for VLAN 1:
Console#show vlan id 1
VLAN ID: 1
Type: Static
Name: DefaultVlan
Status: Active
Ports/Port Channels : Eth1/ 1(S) Eth1/ 2(S) Eth1/ 3(S) Eth1/ 4(S) Eth1/ 5(S)
Table 107: Commands for Displaying VLAN Information
Command Function Mode
show interfaces status
vlan
Displays status for the specified VLAN interface NE, PE
show interfaces
switchport
Displays the administrative and operational status of
an interface
NE, PE
show vlan Shows VLAN information NE, PE