Vlan commands, 34 vlan c, Ommands – Microsens MS453490M Management Guide User Manual
Page 781: Table 103: vlan commands, Vlan c
– 781 –
34
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic VLAN
registration for the selected interface.
Table 103: VLAN Commands
Command Group
Function
Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
Sets up VLAN groups, including name, VID and state
Configures VLAN interface parameters, including ingress and
egress tagging mode, ingress filtering, PVID, and GVRP
Displays VLAN groups, status, port members, and MAC addresses
Configures 802.1Q Tunneling (QinQ Tunneling)
Configures traffic segmentation for different client sessions based
on specified downlink and uplink ports
Configures protocol-based VLANs based on frame type and
protocol
Configures IP Subnet-based VLANs
Configures MAC-based VLANs
Configures VoIP traffic detection and enables a Voice VLAN