Microsens MS453490M Management Guide - Manual (Page 511)

C HAPTER 21 | System Management Commands
File Management
– 511 –
boot system This command specifies the file or image used to start up the system.
S YNTAX
boot system {boot-rom | config | opcode}: filename
boot-rom* - Boot ROM.
config* - Configuration file.
opcode* - Run-time operation code.
filename - Name of configuration file or code image.
* The colon (:) is required.
D EFAULT S ETTING
None
C OMMAND M ODE
Global Configuration
C OMMAND U SAGE
◆ A colon (:) is required after the specified file type.
◆ If the file contains an error, it cannot be set as the default file.
E XAMPLE
Console(config)#boot system config: startup
Console(config)#
R ELATED C OMMANDS
dir (515)
whichboot (516)