Sierra Video TyLinx Pro - Manual (Page 204)

TyLinx Pro Help 204
© 2012 Sierra Video Systems
to be routed and then clicking on a destination control. When selected the source control's color will
change to indicate that it is in a selected state.
Take - Destination to Source
In this scenario a take is made by first clicking on the destination control to where the content is to be
routed and then clicking on a source control that contains the content source. When selected the
destination control's color will change to indicate that it is in a selected state.
Take - With Take Button
Some panel console configurations will include a Take button. When the Take button is present the
operator must select both a source and destination and then follow with clicking the Take button. No
switching occurs until the Take button is clicked.
Take - All Destinations
When enabled for all destinations takes, the operator should see two buttons in the Actions group
label "Select All" and "Un-Select All". When Select All is clicked all destinations become active
indicating they shall participate in the next take. If the Take button is present, the user should select
the source and then click Take. If the Take button is not present simply clicking on a source will effect
the take.
6.2.3 Breakaways
Breakaway is an operation where a subset of levels of a source are routed to a destination and a
subset of levels from another source. This may be done in circumstances where several camera
views with different audio sources are used. For example, during a news broadcast several cameras
views from different angles are used on the news anchor but audio may be sourced from a single
lapel microphone. Ideally, the designer would create separate consoles that allow independent control
of video and audio sources. But in some cases, breakaway actions from a single console needs to be
performed.
Performing a breakaway operation requires the operator to "build" the take using several steps. These
steps vary depending on the console configuration settings but by default panel console properties
may be performed as follows:
1) Select the Destination for the breakaway route: