Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual
Page 216
200
Device Interface IP
address
Device
Interface
IP address
Switch C
Loop0
2.2.2.2/32
—
—
—
Configuration procedure
1.
Configure the IP address and subnet mask for each interface as per
. (Details not shown.)
2.
Configure OSPF on switches in each AS to make sure the network-layer is interoperable among
each AS, and routing information between the switches can be dynamically updated. (Details not
shown.)
3.
Enable IP multicast routing, enable PIM-SM on each interface, and configure a PIM-SM domain
border:
# Enable IP multicast routing on Switch A, enable PIM-SM on each interface, and enable IGMP on
the host-side interface VLAN-interface 200.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] pim sm
[SwitchA-Vlan-interface103] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] igmp enable
[SwitchA-Vlan-interface200] pim sm
[SwitchA-Vlan-interface200] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Switch B, Switch C, Switch D, Switch E, and
Switch F in the same way. (Details not shown.)
# Configure a PIM domain border on Switch B.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim bsr-boundary
[SwitchB-Vlan-interface101] quit
# Configure a PIM domain border on Switch C and Switch E in the same way. (Details not shown.)
4.
Configure C-BSRs and C-RPs:
# Configure Loopback 0 as a C-BSR and a C-RP on Switch B.
[SwitchB] pim
[SwitchB-pim] c-bsr loopback 0
[SwitchB-pim] c-rp loopback 0
[SwitchB-pim] quit
# Configure C-BSRs and C-RPs on Switch C and Switch E in the same way. (Details not shown.)
5.
Configure BGP for mutual route redistribution between BGP and OSPF:
# Configure an EBGP peer, and redistribute OSPF routes on Switch B.
[SwitchB] bgp 100
[SwitchB-bgp] router-id 1.1.1.1
[SwitchB-bgp] peer 192.168.1.2 as-number 200
[SwitchB-bgp] import-route ospf 1
[SwitchB-bgp] quit