H3C Technologies H3C S12500 Series Switches - Manual (Page 233)

217
Solution
1. Use the display ip routing-table command to verify that the unicast route between the devices is
correct.
2. Check that a unicast route is available between the two devices that will become MSDP peer to
each other.
3. Verify the configuration of the originating-rp command. In the Anycast RP application environment,
be sure to use the originating-rp command to configure the RP address in the SA messages, which
must be the local interface address.
4. Verify that the C-BSR address is different from the Anycast RP address.