Configuration procedure, Configuring an ipv6 multicast group filter – H3C Technologies H3C S12500 Series Switches User Manual
Page 367
351
enabled, it must be an MLD querier. For more information about IPv6 PIM-SM and a DR, see
•
A static member port does not respond to queries from the MLD querier. When you configure an
interface as a static member port or remove this configuration on the interface, the interface does
not unsolicitedly send any MLD report or an MLD done message. In other words, the interface is not
a real member of the IPv6 multicast group or the IPv6 multicast and source group.
Configuration procedure
To configure a static member of an IPv6 multicast group or an IPv6 multicast source and group:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure a static member of
an IPv6 multicast group or an
IPv6 multicast source and
group.
mld static-group
ipv6-group-address [ source
ipv6-source-address ]
By default, an interface is not a
static member of any IPv6 multicast
group or IPv6 multicast source and
group.
Configuring an IPv6 multicast group filter
To restrict the hosts on the network attached to an interface from joining certain IPv6 multicast groups,
you can set an IPv6 ACL rule on the interface so that the interface maintains only the IPv6 multicast
groups matching the ACL.
To configure an IPv6 multicast group filter:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Configure an IPv6 multicast
group filter.
mld group-policy acl6-number
[ version-number ]
By default, no IPv6 group filter is
configured on the interface. Hosts
on the current interface can join
any valid multicast group.
Setting the maximum number of IPv6 multicast groups that an
interface can join
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A