Static port configuration example, Network requirements, Configuration procedure – H3C Technologies H3C S12500 Series Switches User Manual

Page 322

Advertising
background image

306

Static port configuration example

Network requirements

As shown in

Figure 82

, MLDv1 runs on Router A, and MLDv1 snooping runs on Switch A, Switch B and

Switch C. Router A acts as the MLD querier.
Host A and host C are permanent receivers of IPv6 multicast group FF1E::101. GigabitEthernet 3/0/3
and GigabitEthernet 3/0/5 on Switch C are required to be configured as static member ports for

multicast group FF1E::101 to enhance the reliability of multicast traffic transmission.
Suppose STP runs on the network. To avoid data loops, the forwarding path from Switch A to Switch C

is blocked under normal conditions, and IPv6 multicast traffic flows to the receivers attached to Switch C
only along the path of Switch A—Switch B—Switch C. Configure GigabitEthernet 3/0/3 on Switch C as

a static router port, so that IPv6 multicast traffic can flow to the receivers nearly uninterruptedly along the

path of Switch A—Switch C in the case that the path of Switch A—Switch B—Switch C is blocked.

NOTE:

If no static router port is configured, when the path of Switch A—Switch B—Switch C gets blocked, at least
one MLD query-response cycle must be completed before the IPv6 multicast data can flow to the receivers

along the new path of Switch A—Switch C. IPv6 multicast delivery will be interrupted during this process.

For more information about STP, see Layer 2—LAN Switching Configuration Guide.

Figure 82 Network diagram

Configuration procedure

1.

Enable IPv6 forwarding and configure an IPv6 address and prefix length for each interface as
shown in

Figure 82

.

2.

On Router A, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable
MLD on GigabitEthernet 3/1/1.

<RouterA> system-view

[RouterA] multicast ipv6 routing-enable

[RouterA] interface GigabitEthernet 3/1/1

Source

1::1/64

Router A

MLD querier

GE3/1/1
2001::1/64

GE3/1/2

1::2/64

Switch A

Switch C

Switch B

GE3/0/1

G

E

3/0

/2

G

E

3/

0/

3

G

E

3/0

/1

GE3/0/2

G

E

3/

0/

1

GE3/0/2

Host C

Host B

Host A

Receiver

Receiver

G

E

3/0

/3

G

E

3/

0/

4

GE3/0/5

Advertising