Wiring the power supply, 4 wiring the power supply – IAI America SCON-C User Manual
Page 44
Advertising
26
3.4 Wiring the Power Supply
3.4.1
Connecting the Power Cable
As shown to the left, insert the stripped end of the cable into the
connector and screw in the cable using a screwdriver.
Recommended cable diameter
Motor power (L1, L2):
2 mm (AWG14)
Control power (L1C, L2C): 0.75 mm (AWG18)
Recommended stripped wire length: 7 mm
As shown to the left, tighten the screws to secure the connector.
Caution: Always install a noise filter.
Recommended noise filter: MC1210 by Densei-Lambda
The power-supply voltage of the controller (100 or 200 V) has been set prior to the shipment.
Advertising