IAI America SCON-C - Manual (Page 67)

49
3.9.3 Connection Cables
The cable used to connect the controller to a regenerative resistance unit is different from the corresponding
cable used on conventional controllers (the connectors are not compatible). To connect a regenerative
resistance unit to the controller, cable [1] specified below is required.
[1] Regenerative resistance connection cable for SCON (CB-SC-REU***)
[2] Regenerative resistance connection cable for conventional controllers (X-SEL, E-Con) (CB-ST-REU***)
Controller end
Wiring diagram
Wire Color Signal Signal Color Wire
Light blue
Brown
Green/Yellow
Receptacle housing:
Receptacle contact:
Sales model nameplate
External regenerative
resistance unit end
Plug:
(Phoenix Contact)
Light blue
Brown
Green/Yellow
Wire Color Signal Signal Color Wire
External regenerative
resistance unit end
Light blue
Brown
Green/Yellow
Light blue
Brown
Green/Yellow
Plug:
(Phoenix Contact)
Plug:
(Phoenix Contact)
Sales model nameplate
Controller end
Wiring diagram