Yokogawa ADMAG AXR - Manual (Page 185)

<14. EXPLOSION PROTECTED TYPE INSTRUMENT>
14-8
IM 01E30D01-01EN
(e) Insert the cable through the union cover, the
union coupling, the clamp nut, the clamp ring,
the gland, the washer, the rubber packing, and
the packing box, in that order.
(f) Insert the end of the cable into the terminal box.
(g) Tighten the union cover to grip the cable.
When tightening the union cover, tighten
approximately one turn past the point where the
cable will no longer move up and down.
Proper tightening is important. If it is too tight, a
circuit break in the cable may occur; if not tight
enough, the flameproof effectiveness will be
compromised.
(h) Fasten the cable by tightening the clamp nut.
(i) Tighten the lock nut on the union cover.
(j) Connect the cable wires to each terminal.
F1407.ai
Adapter body
Rubber packing
Washer
Packing box
Gland
Clamp ring
Clamp nut
Union coupling
Union cover
Wrench
O-ring
Lock nut
Wrench
Lock nut
Cable
Apply a
non-hardnening
sealant to the threads
for waterproofing.
Figure 14.5.3 Installing Flameproof Packing Adapter
(3) Installation
The model AXR□□□C magnetic flowmeter with
optional code JF3 should be used according to 1)
to 4).
1) Follow Figure 14.5.4 regarding the system
configuration.
F1408.ai
Non-hazardous area Hazardous area
Supply+
DO+
DO-
Supply-
Class A
grounding
AXR
Enclosure grounding
(Outside)
Terminal Block
External Instrument
Um=250V
Class D
grounding
Enclosure grounding
(Inside)
Digital output circuit
Supply/ Output signal circuit
Figure 14.1.4 Configuration (TIIS)
2) AXR should be used at ambient temperature
-20°C to 55°C and fluid temperature 130°C or
less.
3) Grounding A should be installed in Non-
hazardous area.
4) Power supply and internal voltage of the
external instrument used with AXR should not
exceed AC 250V 50/60Hz, DC 250V.
(4) Operation
WARNING
After de-energizing, delay 5 minutes before
opening.