Yokogawa ADMAG AXR - Manual (Page 7)

<1. INTRODUCTION>
1-1
IM 01E30D01-01EN
1. INTRODUCTION
This instrument has been adjusted at the factory
before shipment.
To ensure correct use of the instrument, please
read this manual thoroughly and fully understand
how to operate the instrument before operating it.
NOTE
This manual describes the hardware and
software configuration of AXR integral flowmeter.
WARNING
When using the AXR in a Safety Instrumented
Systems (SIS) application, refer to Appendix 1
in this manual. The instructions and procedures
in the appendix must be strictly followed in order
to maintain the designed safety integrity of the
flowmeter.
Model Style Code
AXRG/C S2
n Regarding This User’s Manual
• This manual should be provided to the end
user.
• Before use, read this manual thoroughly to
comprehend its contents.
• The contents of this manual may be changed
without prior notice.
• All rights are reserved. No part of this manual
may be reproduced in any form without
Yokogawa's written permission.
• Yokogawa makes no warranty of any kind with
regard to this material, including, but not limited
to, implied warranties of merchantability and
suitability for a particular purpose.
• All reasonable effort has been made to ensure
the accuracy of the contents of this manual.
However, if any errors or omissions are found,
please inform Yokogawa.
• Yokogawa assumes no responsibilities for this
product except as stated in the warranty.
• Please note that this user's manual may not
be revised for any specification changes,
construction changes or operating part changes
that are not considered to affect function or
performance.
• If the customer or any third party is harmed by
the use of this product, Yokogawa assumes
no responsibility for any such harm owing to
any defects in the product which were not
predictable, or for any indirect damages.
n Safety and Modification Precautions
• The following general safety precautions must
be observed during all phases of operation,
service, and repair of this instrument. Failure
to comply with these precautions or with
specific WARNINGS given elsewhere in
this manual violates safety standards of
design, manufacture, and intended use of the
instrument. Yokogawa assumes no liability
for the customer's failure to comply with these
requirements. If this instrument is used in
a manner not specified in this manual, the
protection provided by this instrument may be
impaired.
• Yokogawa will not be liable for malfunctions or
damage resulting from any modification made
to this instrument by the customer.
• The following safety symbol marks are used in
this user's manual and instrument.
WARNING
A WARNING sign denotes a hazard. It calls
attention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in injury or death of personnel.
CAUTION
A CAUTION sign denotes a hazard. It calls
attention to procedure, practice, condition or the
like, which, if not correctly performed or adhered
to, could result in damage to or destruction of
part or all of the product.
IMPORTANT
An IMPORTANT sign denotes that attention is
required to avoid damage to the instrument or
system failure.