Yokogawa ADMAG AXR - Manual (Page 42)

<5. BASIC OPERATING PROCEDURES
(USING THE DISPLAY UNIT)
>
5-3
IM 01E30D01-01EN
5.2 Display Unit Setting Methods
NOTE
Before changing any settings, be sure to check the corresponding setting details in Chapter 6: Parameter
Description.
5.2.1 Display Mode → Setting Mode
Display Mode will be adopted when the power is turned on, and the Setting Mode can be activated using the
following procedure.
(2 seconds or more)
Select “No”
Display Mode Entry Mode
Parameter Search Mode
Major Item Parameter
Search Mode
Sub-item Parameter
Search Mode
Parameter
Replacement Mode
Setting modes
F0502.EPS
* The term “mode” is used to refer to a situation
where display and setting are possible.
Select “Yes”
ESC
ESC
ESC
SET SET
SET
Sample Display: Procedure for moving from Display
Mode to Setting Mode
100.0
FR
FTL 3274m 3
0 100
m 3 /h
ESC SET
SET
DEC /SHIFT INC
SET ESC INC DEC/SHIFT
F0503-1.ai
Setting switches
Start:
Display Mode
1st line: Actual instantaneous flow rate [FR]
2nd line: Bar graph indicating instantaneous flow rate
3rd line: Totalized forward flow rate [FTL]
Hold the SET switch for 2 seconds.