P138, Connection procedure – Canon XEED WUX450 User Manual

Page 138

Advertising
background image

Connection Procedure

138

Connecting with a BNC cable (Input signal type: [Analog PC-2]

P53

)

Connecting to DVI Monitor Output Terminal (Digital

Connection)

Connecting with a DVI cable (Input signal type: [Digital PC]

P53

)

• Use a VGA-DVI-I cable in which all pins are connected. If the cable is a type in which all

pins are not connected, the image may not be correctly displayed.

• Use an audio cable without a built-in resistor. Using an audio cable with a built-in

resistor will reduce the audio volume.

• The AUDIO IN terminal can be changed in the Audio in terminal select screen (

P153

).

• A signal with a dot clock higher than 162 MHz cannot be projected.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in

resistor will reduce the audio volume.

• The AUDIO IN terminal can be changed in the Audio in terminal select screen (

P153

).

Monitor output terminal

(Mini D-sub 15-pin)

AUDIO output terminal

(AUDIO OUT)

Mini D-sub 15-pin -
BNC terminal
converter cable
(not included)

Mini D-sub 15-pin -
BNC terminal
converter cable
(not included)

BNC cable (not included)

When inputting corresponding audio

Audio cable (not included)

To ANALOG PC-2 /

COMPONENT terminal

Computer

Projector

To AUDIO IN terminal 2

Monitor output terminal

(DVI terminal)

AUDIO output terminal

(AUDIO OUT)

When inputting corresponding audio

Audio cable (not included)

DVI cable (not included)

To ANALOG PC-1 / DVI-I terminal

To AUDIO IN terminal 1

Computer

Projector

Advertising