Canon XEED WUX450 User Manual
Using the Projector in Direct Mode
(7) IP address
To connect to projectors in another subnet, enter the projector’s IP address
here and click (8).
(8) Find projectors
Find the projector with the IP address entered in (7). Results of projector
searching are shown in (9).
(9) Projector information
Indicates the name, installation location, and IP address of the projector
selected in the list or found after searching by IP address.
Passwords for projectors on which [NMPJ Password] on the projector’s
settings screen has been configured (
) must be entered here before
Start projection by the selected projector. During projection, this button is
labeled [Stop projecting] and can be clicked to stop projection.
(12) Switch primary/secondary monitor
A number is shown here only when secondary monitor connectivity is activated
on the computer. Clicking the number will switch between the primary and
(13) Blank the projector
Pause projection. Click again to resume projection.
Display the settings window. (
(15) Projection status
Indicates the projection status.