Input terminal – Canon XEED WUX450 User Manual
(1) AUDIO OUT terminal (AUDIO OUT) (
Outputs the audio to external AV equipment. This outputs the audio signal that
corresponds to the projected image signal.
(2) AUDIO IN terminal (AUDIO IN) (
Receives the audio signal input for 2 kinds of image input other than HDMI.
The internal speaker outputs the audio for the selected image signal.
(3) Terminal for wired remote control (REMOTE) (
This terminal is used to connect the remote control using a cable.
(4) USB port (
Connects a USB flash drive. Used for projection of images on a USB flash
drive, or for firmware updates.
(5) DVI-I input terminal (
Connects the external monitor output from a computer.
Receives analog and digital PC signals (Analog PC-1 and Digital PC,
(6) ANALOG PC / COMPONENT input terminal (
Receives the analog PC signal (Analog PC-2).
A component cable can be used to receive the component image signal
(7) HDMI input terminal (HDMI) (
Receives digital video signals (HDMI).
Carries both video and audio signals across a single cable.
(8) LAN port (
Connects the LAN cable (shielded twisted pair).
Used to connect the projector to a network.
(9) Service port (CONTROL)
It is not used during ordinary use.