Selecting an input signal – Canon XEED WUX450 User Manual

Page 54

Advertising
background image

Step 2 Select an Input Signal

54

Selecting an Input Signal

1

Press the INPUT button to display the window shown below.

The currently active input signal is marked with a green circle and enclosed by
a orange border.
An input signal that is ready for projection is displayed in white. When no signal
is received, it is displayed in gray. However, [Digital PC] or [Analog PC-1] may
be displayed in gray even if these signals are ready for projection.

2

You can switch the available input signal types by pressing the INPUT
button.
You can select the target input signal with [ ] / [ ].

3

Press the OK button to confirm the input signal type.

• Screens of computers connected to the projector over a network can be projected

when you have selected [LAN] as the input signal. For details, refer to Networked Multi-
Projection (NMPJ).

• Images on USB flash drives can be projected when you have selected [USB] as the

input signal. For details, refer to “Projecting Images on a USB Flash Drive” (

P79

).

• In split-screen mode, the side without control rights is identified by a white circle.

Remote control

Projector

Advertising