Installation procedure, Setting up the projector, Positioning the projector in front of the screen – Canon XEED WUX450 User Manual

Page 130: Floor installation, Upward-tilted installation, P130, Adjustable feet

Advertising
background image

130

Installation Procedure

Setting Up the Projector

Positioning the Projector in Front of the Screen

Place the projector in front of the screen.

Floor Installation

To adjust the projection position when the projector is installed on the floor, use the
lens shift function (

P58

and

P134

) to adjust up / down / left / right. You can also use

the adjustable feet to incline the projector upward by up to 6°.
For information about the relationship between screen size and projection distance,
refer to

page 133

.

Upward-Tilted Installation

To correct keystone distortion when the projector is tilted upward (using adjustable
feet, for example), perform keystone correction (

P150

) or corner adjustment

(

P150

).

On some screens, colors may appear
distorted when images are viewed from the
side, but this does not indicate a problem
with the projector. For best results, use a
matte screen with a wide viewing angle
(WUX400ST/WX450ST).

• To avoid keystone distortion, install the

projector so that it is at right angles to the
screen.

• The screen must not be exposed to direct

sunlight or light from lighting equipment. In
a bright room, it is recommended that
lights be turned off, curtains be drawn, and
other steps taken to make the screen
easier to see.

Optical axis

Screen

Viewing areas

where colors may

appear distorted

30°

30°

Optical axis

Screen

Adjustable feet

Lens shift

Advertising