Toshiba Tekbright 700P - Manual (Page 214)

220 Advanced Networking Features
5.375 x 8.375 ver 2.1
4 Change the server name of the second server so the two
servers have different names (for example, myserver and
myserver2).
The client computers can be connected to either of the built in
switches.
Once the servers have been configured, connect them using
ports on their built in switches. An example of this
configuration is shown below:
The two Magnia SG20s are connected using connectors in the
built in switch. Care should be taken to connect from the
crossover port on one system to a non-crossover port on the
other.
Once set up, the two servers are peers on the same network.
The first server will act as the DHCP server for the clients,
which will be able to access the two Magnia SG20s by their
names (myserver and myserver2) or IP addresses
(192.168.1.1 and 192.168.1.2). The clients can be configured
to access either of the systems as their Internet gateway, email
server, DNS server, etc.
Configuring a Magnia SG20 as a Router
It is possible to set up the Magnia SG20 as a router servicing
a local subnet. All clients in that subnet look to the Magnia
SG20 as their gateway to the corporate LAN. The clients and