Toshiba Tekbright 700P - Manual (Page 270)

278 Manually Configuring Clients for the Magnia SG20
Manually configuring clients with Windows NT 4.0, Windows
2000 and Windows XP operating systems
5.375 x 8.375 ver 2.1
❖ From the Start menu on the taskbar, select Settings,
Control Panel, and double-click the Network icon.
If the message “Windows NT Networking is not
installed” appears, you must install a network adapter.
If the Network Properties dialog box appears, click the
Adapters tab. If there are no adapters listed in the Network
Adapters box, you must install a network adapter.
Installing the NIC with the Windows NT operating
system
1 Click Start, Settings, Control Panel, and double-click
the Network icon.
2 If the message “Windows NT Networking is not
installed. Do you want to install it now?” appears, click
OK.
3 Follow the prompts, accepting all default values
presented after you have correctly identified your
network adapter card. Select to enable DHCP when (and
if) asked. You will need both your Windows NT Setup
Disk and your network adapter setup disk.
4 Restart the client computer.
The steps for completing the installation depend on the
requirements of the network interface. Follow the instructions
for each prompt. When installation is complete, you will need
to restart the computer.
Before restarting the computer, make sure that the Ethernet
cable is properly connected to both the network adapter card
and the Magnia SG20. After the computer restarts, you will
be ready to continue with your client configuration network
settings.