Toshiba Tekbright 700P - Manual (Page 272)

280 Manually Configuring Clients for the Magnia SG20
Manually configuring clients with Windows NT 4.0, Windows
2000 and Windows XP operating systems
5.375 x 8.375 ver 2.1
5 Select Create a New Connection from the left frame. If
prompted, enter the area code and close the dialog box.
The New Connection Wizard appears.
6 Click Next. The Network Connection Type page appears.
7 Select Connect the network at my workplace, and click
Next.
8 Enter the IP address for your Magnia SG20 and click
Next.
9 Click Finish.
Networking settings
Once you have a properly installed network adapter card, you
need to make additional network settings so that the client
computer can communicate with the Magnia SG20. You may
need your Windows
® operating system setup disk to complete
this process.
NOTE: With the Windows NT, Windows 2000 and Windows XP
operating systems, if a network adapter was previously properly
installed and was subsequently removed, you may believe that the
network adapter card is working, when in fact it is not present. If
you complete the steps to establish your network settings, and
these continue to fail, verify that the network adapter card is still
physically installed in the client computer.
Determining network settings
To determine your client computer network settings:
1 Click Start, then select Programs.
2 For the Windows NT ® operating system, click
Command Prompt.
For the Windows ® 2000 operating system, select Accessories,
then click Command Prompt.