Toshiba Tekbright 700P - Manual (Page 75)

76 Setting Up Your Local Area Network
More about connecting client computers
5.375 x 8.375 ver 2.1
More about connecting client computers
The “Quick start procedure” on page 20 explains the basics
of connecting and configuring client computers for the local
network if you have already set it up.
You can connect clients to the Magnia SG20 and configure
them quickly and easily using the Magnia SG20 "Client
Setup- and Documentation CD". This is the recommended
method of setting up client computers for your private
network.
The "Client Setup- and Documentation CD" will modify your
client computer’s network configuration to match that of the
Magnia SG20. If your client computer is already configured
for use with another network (such as a corporate LAN), you
may wish to manually configure your client for Magnia SG20
access.
If you need to set up client computers without using the
"Client Setup- and Documentation CD", see
“Manually
Configuring Clients for the Magnia SG20” on page 261 . To
configure a Macintosh, see “Configuring a Macintosh as a
Client” on page 291 .
Dial-in access
The Magnia SG20 has either a built-in modem or an ISDN
adapter that allow users to log in to the network from remote
locations (such as their homes) over a phone line. If you
would like to allow users to connect via modem or ISDN, you
must first connect the Magnia SG20 to a working phone line.
1 Connect a cable from the modem port to the telephone
jack or from the ISDN port to your ISDN telephone jack.
2 At the remote location, connect the computer to the
telephone line.