Toshiba Tekbright 700P - Manual (Page 239)

246 If Something Goes Wrong
Problems when you turn on the Magnia SG20
5.375 x 8.375 ver 2.1
The system reset button is just inside the tiny hole labeled
Reset
The “Magnia SG20” message does not go away.
It should normally show this message for 30 seconds to a
minute. However, if the Magnia SG20 was powered off
abruptly and not shut down as expected, then the warming up
message could take up to five minutes.
It is also possible that your primary hard disk drive cannot be
recognized. If you recently inserted a new hard disk drive or
adjusted your hard disk drive(s), check your hard disk drive
connection(s). You might want to remove and reinsert your
hard disk drive(s).
The Magnia SG20 does not display the expected
“Magnia SG20” and date/time messages.
Make sure you attached the power cable properly.
Unplug the Magnia SG20 and plug it back in again.
One or more clients configured for DHCP cannot access
the Magnia SG20. Such clients might include a PC, a
PocketPC device, or a TurtleBeach AudioTron.
Since the DHCP server on the Magnia SG20 was just
restarted, some clients may not know it's time to request a
new IP address. To resolve this issue, wait until the appliance
server is fully booted, then reboot any client device that is not
able to communicate with the appliance server. For the
Audiotron, use the power switch in the back of the unit.
Reset