Toshiba Tekbright 700P User Manual
Page 40
40
Getting Started
Configuring wireless access
5.375 x 8.375 ver 2.1
2
Select the Enable Wireless Access Point check box to
enable wireless access. Clear the check box to disable
wireless access.
3
In the Network Name box, enter your network name
(sometimes known as the ESSID).
Each wireless client is configured using the same
network name. If there is more than one wireless access
point, the network name determines which access point
each wireless client uses.
4
In the Channel box, select which radio frequency to use
for wireless communications.
This same frequency must also be specified in each
wireless client’s configuration.
5
Select the Enable Data Encryption check box to
encrypt information sent between wireless clients and the
Magnia SG20. Clear the check box to disable encryption.
This feature is known as Wired Equivalent Privacy
(WEP).
6
If you enabled data encryption in
, click the
Configure hyperlink next to the Enable Data
Encryption check box to set up or modify the required
encryption keys (passwords).
See
“Configuring Wired Equivalent Privacy (WEP) keys”
for further instructions.
7
Select the Enable Access Control check box to specify
the wireless clients that can access your network, using
each client’s unique network card MAC address.
This security feature allows only the specified clients to
access the network through the wireless access point. See
“Configuring access control” on page 43
for further
instructions.
8
Select the Enable SSL (Secure Sockets Layer) check box
to use HTTPS (Secure Hyper Text Transfer Protocol) to