Toshiba Tekbright 700P - Manual (Page 258)

266 Manually Configuring Clients for the Magnia SG20
Manually configuring clients using the Windows 95, 98 and
Windows Me operating system
5.375 x 8.375 ver 2.1
Installing the network card using Windows 95 or 98
operating systems
1 Click Start, Settings, Control Panel and double-click
Network.
The Network Properties dialog box appears.
If there is no adapter (or only the Dial-Up Adapter) listed
in the box labeled “The following network components
are installed:” continue with these steps to install your
network adapter card.
2 On the Configuration tab of the Network Properties
dialog box, click Add.
3 When the Select Network Component Type dialog box
appears, click Adapter in the list, then click Add.
4 When the Select Network Adapter dialog box appears,
either locate the manufacturer and adapter from the
provided list and click OK or, if you have the driver disk
handy, click Have Disk and follow the prompts.
5 For systems with the Windows
®
98 operating system,
when your network adapter card has been installed, you
may be returned to the Network Properties dialog box. If
this happens and you are not prompted to restart your
computer, click OK and allow the client computer to
restart.
The steps for completing the installation depend on the
requirements of the network interface. Follow the instructions
for each prompt. When installation is complete, you will need
to restart the computer.
Before restarting the computer, make sure that the Ethernet
cable is properly connected to both the network adapter card
and the Magnia SG20. After the computer restarts, you will
be ready to continue with your client configuration network
settings.