Leica Biosystems CV5030 - Manual (Page 22)

22 Instructions for Use V 3.0 RevE – 04/2013
• Open the hood and place a suitable spirit level
(26) onto the work surface as shown in Fig. 6 .
• The instrument can be leveled in both direc-
tions by screwing or unscrewing the instru-
ment feet (27) ( detail 2 in Fig. 6 ).
4.4 Leveling the instrument
Fig. 6
27
• Move the instrument to its final location on the
work surface.
When doing so, ensure that all four feet are
on the work surface.
Detail 2
4. Instrument Setup
4.5 Exhaust system
26
We recommend operating the robotic coverslipper with an exhaust hose and connection to ex-
ternal laboratory extraction or under a suitable fume hood. The associated active carbon filter
is intended to be used in a supporting role for this. We recommend replacing the active carbon
filter every three months. Please note that the active carbon filter, when used alone, can filter
only a limited number of harmful vapors (e.g. xylene). The setup location can differ substan-
tially in terms of solvent loading, room ventilation, room/ambient temperature, room size, etc.
In case of doubt, the laboratory owner/operator must have measurements conducted on site to
ensure that the legal limits for solvent vapors are not being exceeded.