Lenze EVS93xx FlyingSaw - Manual (Page 102)

FlyingSaw
Description of the function blocks
 Prepared Solution Servo PLC / ECSxA 1.1 EN 10-4
10.2 Function block Software_Limit
This function block monitors the software limit positions set. The block is only active after
homing has been performed. This means that during homing only the hardware limit positions
(physical limit switches) are actively monitored.
The position entry for the positive and negative software limit switches must not be equal to
zero and be within the possible limits so that the software limit positions are monitored.
Task information
Can be called in: Cyclic task Time-controlled task
(INTERVAL)
Event-controlled task
(EVENT)
Interrupt task
Inputs (Variable type: VAR_INPUT)
Identifier Data type Value/meaning
dnActPos DINT
Actual phase position of the axis "flying saw"
¾ 65536 inc correspond to one revolution on the motor end
dnPosLimitSwitch DINT Input for the position of the positive software limit switch
¾ The entry is made in the application unit [units] and must have the value > 0.
The reference here is the home position.
¾ The software limit position is only active for an entry > 0.
dnNegLimitSwitch DINT Input for the position of the negative software limit switch
¾ The entry is made in the application unit [units] and must have a value <0. The
reference here is the home position.
¾ The software limit position is only active for an entry <0.
bHomePosAvailable BOOL Input for the signal "Homing done"
¾ The software limit position monitoring is only activated once the home position
is known
Axis MC_AXIS_REF Machine parameters
¾ Data structure with elements that contain the machine parameters in the
internal measuring system.
¾ Connect this input to a global variable written by the FB L_MCMachineData.
Outputs (Variable type: VAR_OUTPUT)
Identifier Data type Value/meaning
bPosLimitActive BOOL Status signal "Positive software limit position reached"
bNegLimitActive BOOL Status signal "Negative software limit position reached"
bSwitchActive BOOL Status signal "Software limit position monitoring active"