Lenze EVS93xx FlyingSaw - Manual (Page 14)

FlyingSaw
Features of the Prepared Solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-1
2 Features of the Prepared Solution
In the following, the key features and functions of the flying saw are given as bullet points.
The Prepared Solution includes the following functions:
• Homing, determining the reference position of the axis
• Inching mode, manual positioning of the axis
• Absolute
positioning
• Top cut at "zero" line speed
• Top cuts independent of the position (away from the initial position)
• Length counter for the total running metres
• Cutting length control (length calculator)
• Cutting mark control (touch probe, mark)
(with monitoring of the "forced cut" mark detection)
• Top cut counter for the number of top cuts carried out
• Cut counter for the total number of pieces
• Scrap counter (externally triggered)
• "Synchronous" synchronisation to a master speed
• "Oversynchronous" synchronisation to a master speed
• Simulation of the material line using adjustable, virtual line speed
• Correction value definition for the straightforward compensation of slip at the measuring
wheel
• Error handling (system and application-specific error messages)
• Limit switch monitoring
• Software limit switch monitoring